C-SCOPE SG-V Instrukcja Obsługi Pobierz pdf (Strona 36)

Pipe Tracing using a Sonde: Batteries

Duct Sonde

The Duct Sonde is supplied at 33kHz only (yellow casing)

and is powered by a single AAA (LR03) size alkaline battery.

1. To turn the Duct Sonde on, use a large flat bladed

screwdriver to unscrew the battery cover located within

the hollow end of the Sonde casing. Insert a new battery

into the battery compartment with the positive end down.

2. Replace the battery cover fully using the screwdriver to

secure. The Duct Sonde is now transmitting a signal.

3. To turn the Sonde off the battery must be removed.

NOTE Only use alkaline batteries. Dispose of the used battery safely in accordance with local regulations.

NOTE Always use a new battery in a Sonde if you expect to take a long time to trace the pipe or duct route.

WARNING The Locator frequency MUST always be set to the same frequency as the Sonde.

-----

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 55 56

Brak uwag

C-SCOPE SG-V Instrukcja Obsługi Strona 36